Daewoo Nexia

Since 1994 of release

Repair and car operation

Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Fuel and exhaust systems
- Electric chain
   6.2. The general description
   6.3. Rules of care of the accumulator
   6.4. Accumulator check
   6.5. Accumulator gymnastics
   6.6. The storage battery
   6.7. System of start-up of the engine
   6.8. Diagnostics of malfunctions
   6.9. Algorithm of diagnostics of malfunctions
   6.10. The traction relay
   6.11. Муфта a free wheeling (МСХ)
   6.12. Repair of knots of a starter 5МТ and 10МТ
   6.13. The generator
   6.14. Diagnostics of malfunctions of generator CS-121
   6.15. Generator dismantle
   6.16. Generator CS-130 repair
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment

6.11. Муфта a free wheeling (МСХ)

1. To check up work МСХ. The starter gear wheel should rotate freely in one direction and be blocked with electric motor shaft at attempt to turn it in other direction. To check up a gear wheel condition: teeths should not have cracks, the centres выкрашивания metal and strong deterioration. At detection of defects to replace МСХ and a gear wheel. Contact damages of a gear wheel can be also a sign выкрашивания teeths of a wreath of a flywheel. It is necessary to check up a condition of a wreath of a flywheel and if necessary to replace a wreath.

2. To check up a twisting moment of blocking МСХ. For this purpose it is necessary, without dismantling МСХ from a shaft, to clamp an electric motor anchor in a vice. In order to avoid damages to wrap up an anchor a fabric. To put on on МСХ a tip динамометрического a key and to put the twisting moment of 68 Nanometers directed counter-clockwise. Thus МСХ it should not be turned. If МСХ it was turned, it is necessary to replace it.

3. Roller МСХ does not require greasing while in service. However it is necessary to clear it of a dirt. It is forbidden to use for clearing МСХ of means which can разжижить and wash up from МСХ the put greasing. For greasing of a neck of a shaft of an anchor on which it is placed МСХ, siliceous greasing General Electric CG321, greasing Dow Coming 33 Medium and others similar to them is applied.

4. It is not necessary to grease details МСХ plentifully.