Daewoo Nexia

Since 1994 of release

Repair and car operation



Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Fuel and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
- Running gear
   13.2. Replacement of wheels
   13.3. Wheel bolts
   13.4. Обкатка tyres
   13.5. Storage of tyres
   13.6. Balancing of wheels
   13.7. Chains противоскольжения
   13.8. Pressure check in tyres
   13.9. Check of a profile of tyres
   13.10. Gate check
   13.11. Corners of installation of wheels of the car
   13.12. Preliminary check of a technical condition
   13.13. Adjustment of a convergence of forward wheels
   13.14. Check of a convergence of back wheels
   13.15. Check of a corner of disorder of back wheels
   13.16. Designations of wheel disks and tyres
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment




13.13. Adjustment of a convergence of forward wheels
THE GENERAL DATA

Adjustment of a convergence of forward wheels

AND. TO ADJUST THE CONVERGENCE OF WHEELS SCREW ROTATION
Century to WEAKEN the INHALING of BOLTS КЛЕММОВЫХ of CONNECTIONS. AFTER ADJUSTMENT to TIGHTEN the MOMENT of 20 Nanometers

1. THE TIP OF STEERING DRAUGHT
2. SPRING СТОИКА SUSPENSION BRACKETS

The convergence of forward wheels is regulated by change of length of steering draughts. To release bolts In клеммовых clips on the left and right steering draught. Then rotation of adjusting screws And to establish demanded value of a convergence of forward wheels. Thus lengths of steering draughts should be identical.

To tighten bolts клеммовых connections of steering draughts by the moment of 20 Nanometers.