Daewoo Nexia

Since 1994 of release

Repair and car operation

12.37. A steering column

THE GENERAL DATA

---

The prevention

The steering column is subject to dismantle only in following cases:

– The steering column demands replacement;
– The case for fastening of the lock of ignition and the blocking device of a steering shaft demands replacement;
– Other cases of repair connected with removal from the car of a steering column.

---

To remove or disconnect

PERFORMANCE ORDER

1. A negative wire of the battery. 2. Control levers indexes of turns and a screen wiper. 3. Electric conducting. 4. A flexible cable of the blocking device of the selector of ranges of a transmission and the ignition lock (only for cars with automatic transmission). 5. To establish a steering wheel in the neutral position corresponding to rectilinear movement of the car. 6. To turn out a coupling bolt клеммового connections муфты a steering shaft. 7. To turn out a bolt of fastening of an arm of a steering column to the instrument panel. 8. Sreznye plates under the instrument panel. 8а. Накернить a head left срезного a bolt. 8б. To drill an aperture a special drill for extraction of bolts (diameter of a drill 1/8 "– 3,175 mm). 8в. To insert into the drilled aperture adaptation N1411 for removal of bolts and to turn out срезной a bolt. 9. To remove a steering column and cautiously to put on support.

To establish or attach

Installation of a steering shaft

AND. THE CASING OF THE STEERING COLUMN CENTURY THE STEERING SHAFT WITH. THE ALIGNING PLUG D. COUPLING BOLT МУФТЫ

Installation срезного a bolt of a steering column

AND. WASHER СРЕЗНОГО OF THE BOLT CENTURY СРЕЗНОЙ THE BOLT WITH. THE ARM OF THE CASING OF THE STEERING COLUMN

PERFORMANCE ORDER

1. To turn a steering wheel so that spokes were symmetrized concerning a vertical and have been directed downwards (position of a steering wheel for rectilinear movement of the car). 2. To establish aligning plug in a casing of a steering column. 3. To establish рейку the steering mechanism in the average position corresponding to rectilinear movement of the car. 4. To turn coupling a steering shaft so that an axis of an aperture for a coupling bolt settled down horizontally and from above a shaft. 5. Cautiously to insert a shaft of a steering shaft into an aperture муфты. The prevention It is necessary to support a steering column until it will not be fixed срезным by a bolt. It is forbidden to leave a steering column without a support. 6. To establish (without tightening) following fixing details:       – срезные plates on the instrument panel;       – A bolt of fastening of an arm of a casing of a steering column to the instrument panel. To tighten a bolt of fastening of an arm of a steering column to the instrument panel the moment of 22 Nanometers;       – A coupling bolt клеммового connections муфты with steering shaft. (The bolt should be inserted into a smooth aperture without a carving). To tighten срезной a bolt located to the left of a steering column, the moment of the demanded size;       – New самоконтрящуюся a nut (with a washer), located to the right of steering колот and the moment of the demanded size. 7. To extend a steering shaft upwards (against the stop the ball bearing of a shaft). To tighten a coupling bolt клеммового connection муфты a steering shaft the moment of 25 Nanometers. 8. To take out directing plug from a column casing, having left it on the helmsman to a shaft. 9. To attach electroconducting. 10. To attach a cable of a drive of the blocking device of the lock of ignition and the transmission selector (only for cars with automatic transmission). 11. To establish control levers indexes of turn and a screen wiper. 12. To check up installation of operated wheels in position for rectilinear movement. 13. A negative wire of the battery.