Daewoo Nexia

Since 1994 of release

Repair and car operation



Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Fuel and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
- 14. A forward suspension bracket
   14.2. The general description
   14.3. Check of size of forces of a friction in a suspension bracket
   14.4. Condition check подшипниковых support and spherical hinges
   14.5. The stabilizer
   14.6. A rack in gathering with подшипниковой a support
   14.7. The bottom lever
   14.8. The spherical hinge
   14.9. A nave and the wheel bearing
   14.10. The top support
   14.11. Springs
   14.12. The shock-absorber
   14.13. Plugs of hinges of the bottom lever
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment




14.11. Springs
THE GENERAL DATA

Adaptations for spring compression


Arrangement of a support of a spring


To remove or disconnect

PERFORMANCE ORDER
1. The top support.
2. To dismiss the spring compressed in the adaptation, to remove and replace.

To establish or attach

PERFORMANCE ORDER
1. To put on a new spring a rack and to compress it by means of adaptations KM-465A and КМ-329А. The spring end should lean against the bottom cup of a rack. The springs established on the right and left racks, are interchangeable. The ledge on a plastic support of a spring serves as a reference point at rack installation. If to look in a direction of movement of the car, the ledge on a support of the left rack should settle down in front, and on a support of the right rack – behind.
2. The top support of a rack.