Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Fuel and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
- 14. A forward suspension bracket
14.2. The general description
14.3. Check of size of forces of a friction in a suspension bracket
14.4. Condition check подшипниковых support and spherical hinges
14.5. The stabilizer
14.6. A rack in gathering with подшипниковой a support
14.7. The bottom lever
14.8. The spherical hinge
14.9. A nave and the wheel bearing
14.10. The top support
14.11. Springs
14.12. The shock-absorber
14.13. Plugs of hinges of the bottom lever
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment
|
The description of operations on dismantle of a telescopic rack is resulted in subsection 14.6.
To remove or disconnect
| PERFORMANCE ORDER |
| 1. To compress a suspension bracket spring. |
| 2. A protective cover of the top support. |
| 3. A nut 35 and a washer 34. (To Use adaptation J36710). |
| 4. To dismiss a spring. |
| 5. The top support of 39 racks, тарельчатую a washer 40, a plastic support 41, a protective casing of a rack 42, the top lining of a spring 43, a spring 44, the buffer of compression 45, the bottom lining of a spring 46. |
| 6. A screw cover of 31 racks by means of key КМ-331. The cover is tightened by the considerable moment of 200 Nanometers. |
| 7. The shock-absorber 32. |
|
To clear
| PERFORMANCE ORDER |
| 1. A rack female thread. |
| 2. To use a new carving cover 31 of the complete set of spare parts of the shock-absorber. |
|
To establish or attach
The prevention The new cover 31 is covered by paraffin which should not be deleted. Paraffin simultaneously is lubricant and protects from corrosion.
| PERFORMANCE ORDER |
| 1. A cover 31. To use a new cover. To tighten a screw cover of 31 racks the moment of 200 Nanometers. |
2. To establish a rack in adaptations for spring compression.
The prevention Before installation of the top support of a rack it is necessary to be convinced that the support ball-bearing is greased properly.
|
| 3. Following details: 46, 45, 44, 43, 42, 41, 40, 39. |
| 4. To compress a spring. |
| 5. A washer 34. |
| 6. A nut 35. To tighten a nut of 35 fastenings of a rod the moment of 55 Nanometers. |
| 7. Operations on installation on the car of a rack of a suspension bracket are described in subsection 14.6. |
|
|
|