Daewoo Nexia

Since 1994 of release

Repair and car operation

Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Fuel and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
- 14. A forward suspension bracket
   14.2. The general description
   14.3. Check of size of forces of a friction in a suspension bracket
   14.4. Condition check подшипниковых support and spherical hinges
   14.5. The stabilizer
   14.6. A rack in gathering with подшипниковой a support
   14.7. The bottom lever
   14.8. The spherical hinge
   14.9. A nave and the wheel bearing
   14.10. The top support
   14.11. Springs
   14.12. The shock-absorber
   14.13. Plugs of hinges of the bottom lever
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment

14.13. Plugs of hinges of the bottom lever To remove or disconnect

Operations on dismantle of the bottom lever are described in subsection 14.7.

To disassemble

Dismantle of the back plug of the lever

AND. THE PRESS
CENTURY THE PUSHER
WITH. THE PRESS EMPHASIS

13. THE BOTTOM LEVER

Dismantle of the forward plug of the lever

AND. THE PRESS
CENTURY THE PUSHER
WITH. THE PRESS EMPHASIS

13. THE BOTTOM LEVER (ВЫПРЕССОВЫВАТЬ IN THE DIRECTION IN FRONT BACK)

PERFORMANCE ORDER

1. The plug of a back support of the lever. Выпрессовать the plug by means of a pusher.

2. The plug of a forward support of the lever by means of adaptation KM-508A and a punch выпрессовать the plug in a direction in front back.

To collect

Installation of the back plug of the lever

AND. THE PRESS
CENTURY TO MOISTEN WITH THE SOAP SOLUTION
WITH. THE PRESS EMPHASIS

13. THE BOTTOM LEVER
14. THE BACK PLUG OF THE LEVER THE FLAT PARTY OF THE PLUG SHOULD SETTLE DOWN FROM THE SAME PARTY, AS THE FINGER OF THE SPHERICAL HINGE

PERFORMANCE ORDER

1. The plug of a back support of the lever.

1а. To moisten a back thorn of the lever with a soap solution and напрессовать on it the plug. The flat party of the plug 14 should settle down from above, from the same party, as a finger of the spherical hinge.

2. The plug of a forward support of the lever.

2а. To moisten with a soap solution an external surface of the plug.

2б. Запрессовать the new plug in a lever aperture. Plug installation to make from the forward party of the lever.

To establish or attach
Operations on installation of the bottom lever on the car are described in subsection 14.7.