Daewoo Nexia

Since 1994 of release

Repair and car operation

Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Fuel and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
- 15. A drive of forward wheels
   15.2. The general description
   15.3. Kardannye shaft in gathering
   15.4. An external reflective ring
   15.5. A cover of the external hinge
   15.6. The external hinge
   15.7. A cover of the internal hinge of type "Tripod"
   15.8. A cover of the hinge of type "Lebro" with cross flutes
   15.9. Consolidation propeller a shaft in crankcase transmissions
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment

15.9. Consolidation propeller a shaft in crankcase transmissions

THE GENERAL DATA

Consolidation propeller a shaft in crankcase transmissions

A.CARTER OF TRANSMISSION

5. THE BALL-BEARING
10. THE DETAIL OF FASTENING THE SHRUS
13. SHAFT CONSOLIDATION

To remove or disconnect

Consolidation dismantle

A.CARTER OF TRANSMISSION

Exit propeller a shaft from crankcase transmissions

AND. THE SCREW-DRIVER
CENTURY THE HAMMER

7. THE COLLAR
8. THE COVER
10. THE SHAFT

The description of operations 1, 2 and with 4th on 8th in subsection 15.3 see.

PERFORMANCE ORDER

1. To substitute under crankcase transmissions the pallet for oil plum.

2. By means of the tool to take out карданный a shaft from crankcase transmissions. After dismantle of a shaft from crankcase to fix a shaft.

3. To dismantle consolidation.

4. To examine a landing nest of a cuff and the working surface contacting to an edge of a cuff.

To establish or attach

Consolidation installation

AND. THE HAMMER WITH PLASTIC THE BRISK

PERFORMANCE ORDER

1. Consolidation propeller a shaft.

1а. To grease a cuff трансмиссионным with oil.

2. A kardannyj shaft. To check up reliability of fixing of a spring ring in a flute.

3. Spherical hinges of the bottom lever and steering draught. To tighten a nut of the spherical hinge of steering draught the moment of 60 Nanometers. To establish pin if it is provided. To tighten a nut of the spherical hinge of the bottom lever of a suspension bracket the moment of 70 Nanometers. To establish a spring clamp.

4. A wheel.

5. To lower the car on a floor.

6. To tighten bolts of fastening of wheels the moment of 90 Nanometers.

7. To tighten nuts of fastening of the top support of a telescopic rack to the Body the moment of 30 Nanometers.

8. A wheel cap.

9. To check up level transmission oils and to finish it to norm.