Daewoo Nexia

Since 1994 of release

Repair and car operation

16.5. Bearings of wheels

THE GENERAL DATA

Normal work of a back suspension bracket is impossible without correct adjustment of a preliminary tightness of conic roller bearings of wheels.

To adjust

PERFORMANCE ORDER

1. To remove a protective cap of 17 naves 12. 2. To take out pin 15 of a pin aperture. 3. Rotating a hand a wheel in a direction corresponding to movement of the car by a forward course, to tighten a nut 16 moment of 25 Nanometers for dense compression of rings of bearings. Thus from bearings and their nests superfluous greasing and bearings is squeezed out are correctly established in nests, eliminating the possible reasons of increase axial люфта. 4. Completely to release a nut 16. 5. To tighten a nut 16 effort of a hand. Then to release it before aperture coincidence in a pin from one of cuts корончатой nuts, but no more, than on half of turn. 6. To establish new pin and to bend its ends. 7. To measure an axial backlash. At correct adjustment of bearings the axial backlash should make 0,03–0,13 mm. 8. To insert a protective cap 17 into a nave 12.