Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Fuel and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
- 16. A back suspension bracket
16.2. The general description
16.3. Maintenance service and repair
16.4. Check of size of forces of a friction in a suspension bracket
16.5. Bearings of wheels
16.6. The shock-absorber
16.7. The stabilizer
16.8. Springs
16.9. Plugs of hinges of a back suspension bracket
16.10. A back suspension bracket in gathering
16.11. A nave
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment
|
The top support of the shock-absorber
|
|
AND. 9 MM
2. THE NUT OF THE TOP SUPPORT OF THE SHOCK-ABSORBER
3. THE WASHER
4. THE RUBBER WASHER
7. THE SHOCK-ABSORBER (ROD) |
To remove or disconnect
| PERFORMANCE ORDER |
| 1. To open a luggage carrier cover. |
| 2. A cap 1 if is available. Then to turn away a nut of 2 fastenings of a rod of the shock-absorber. At replacement of both shock-absorbers it is necessary to dismantle them and to replace serially, on one for time. |
| 3. To lift the car and to fix levers of a back suspension bracket. At опирании on paws of the lift of the Body of the car it is necessary to bring adjustable support under a beam of 26 suspension brackets. At опирании on paws of the lift of levers of a suspension bracket it is necessary to be convinced preliminary of correct position of paws concerning basic elements of suspension brackets. |
4. To turn away a nut of 9 fastenings of the bottom eye of one of shock-absorbers and to take out a bolt 8. To replace the shock-absorber.
The prevention It is forbidden to dismantle at once both shock-absorbers as lowering of a beam of a back suspension bracket can lead to damage of pipelines and flexible hoses of a brake drive.
|
|
To establish or attach
| PERFORMANCE ORDER |
| 1. To insert a bolt 8 into an arm of the lever of a suspension bracket and the bottom eye of the shock-absorber. To screw a nut 9, without tightening. |
| 2. To lower the car so that to have possibility to insert a shock-absorber rod in an assembly aperture of a basic glass of the Body and to screw a nut 2, without tightening. |
| 3. To tighten a bolt of the bottom support of the shock-absorber the moment of 70 Nanometers. |
| 4. To remove support of a beam of a suspension bracket and completely to lower the car. To screw a nut 2 so that a carving shaft of a rod of the shock-absorber left on 9 mm. |
| 5. To establish into place a cap 1 (if its presence is provided). |
|
|
|