Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Fuel and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
- 16. A back suspension bracket
16.2. The general description
16.3. Maintenance service and repair
16.4. Check of size of forces of a friction in a suspension bracket
16.5. Bearings of wheels
16.6. The shock-absorber
16.7. The stabilizer
16.8. Springs
16.9. Plugs of hinges of a back suspension bracket
16.10. A back suspension bracket in gathering
16.11. A nave
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment
|
The prevention At replacement of springs of a back suspension bracket not to use the two-rack-mount lift. At dismantle of details of a back suspension bracket stability of position of the car can be broken and falling of the car from the lift is possible. If there is no four-rack-mount lift травмирования the work personnel it is possible to spend to avoidance directly on a floor.
To remove or disconnect
| PERFORMANCE ORDER |
| 1. To lift the car and to fix in appropriate way. At possible сти follows опирать lift paws on a car Body. To bring basic racks under levers of a back suspension bracket. At use of the two-rack-mount lift опереть paws on the Body and to bring basic racks under suspension bracket levers. |
| 2. Fastenings left and right трубопрово дов a brake drive to an arm on the bottom of the Body Pipelines should hang freely. |
| 3. To turn away a nut and to disconnect a cable of a lay brake from the equalizer. |
| 4. To disconnect brake hoses and to close their caps or stoppers in order to avoid dirt hit. |
5. The right and left bolts of 8 fastenings of shock-absorbers.
The prevention It is forbidden to dismantle support of shock-absorbers, preliminary without having disconnected brake hoses Otherwise damage of brake hoses is possible.
|
| 6. To lower a beam of 26 suspension brackets and демонти ровать one or both springs 28 and-or the top elastic ring 29. |
|
To establish or attach
Before spring installation it is necessary to establish preliminary on glue in the Body nest the top elastic ring 29. The ring should be on a place at lifting of a beam 26 with springs 28 in assembly position.
| PERFORMANCE ORDER |
| 1. The top elastic ring 29, the bottom buffer 27, a spring 28 and to lift a beam 26. |
|
2. The bottom eyes of shock-absorbers 7 to arms of levers. To tighten bolts 8 moment of 70 Nanometers. Before tightening bolts 8, it is necessary to lift a beam of a back suspension bracket in the position corresponding to a static course of a suspension bracket. |
| 3. Brake pipelines to arms on the Body bottom. |
| 4. Brake hoses and to remove air from a brake drive of back wheels. |
| 5. A cable of a lay brake to adjust a lay brake. |
| 6. To remove basic racks and to lower the car. |
|
|
|